Rally Bar Huddle

Rally Bar Huddle Multi-Mount Quick Guide

Rally Bar Huddle Multi-Mount Guide

This article explores a quick multi-mount guide: Attach Mount, Table Mount, Mount to Wall, Mount to Display.

Rally Bar Huddle comes with a multi-mount that allows the device to be mounted on a tabletop, on the wall, or above the display.

Note: Mount screws for the Rally Bar Huddle, when using TV Mount for Video Bars, can be replaced with 1/4-20 at approximately 9-10mm long.

Front

Back

Attach Mount

  • Open the primary hinge and locate the D-Ring

  • Align tripod screw and registration studs. Turn the D-Ring clockwise until the device sits flush on the mount

Step 1:

Step 2:

 

Table Mount

Note: Rally Bar Huddle cannot be set directly on a table surface. The downward firing port on the right side of the device requires clearance from flat surfaces.

Attach Rally Bar Huddle to the multi-mount and tilt the foot from the horizontal to the vertical position.

 

Mount to Wall

The multi-mount can be mounted to the wall in 2 different ways. Either with no screws removed and the mount visible, or screws removed and the mount hidden.

Mount Visible (no screws removed)

  • Open the primary hinge so that the mount platform is at a 90° angle to the back plate

  • Use VESA holes and appropriate hardware to affix the mount to the wall

Mount Hidden (remove 4 screws)

  • Remove 4 screws from the multi-mount and separate the 2 pieces

  • Extend the 2 black tabs on the mount platform

  • Rotate the back plate 180°

  • Insert the 4 screws to the underside of the fixed tabs on the back plate

  • Use VESA holes and appropriate hardware to affix the mount to the wall

Steps 1-4:

Step 5:

 

Mount to Display

Note: when mounted to a display Rally Bar Huddle can be tilted downward to a maximum of 25°

Mounting Rally Bar Huddle to the display requires the use of the included display holster.

  • Test fit the monitor clamp on the multi-mount by placing it against the back of the display with the display holster attached and mark its location

  • Follow the 3M instructions for application of the holster here: Mount Command Strips

  • Attach Rally Bar Huddle to the multi-mount (if not already attached)

  • Slide the mount assembly into the display holster

Step 1

Step 2

Step 4

AI assisted translation
Menu