MeetUp 2 Wiring Diagram Guide

Below, you will find a collection of different room configurations specific to MeetUp 2 that link directly to the corresponding page of our Wiring Diagram. Most of the configurations below are shown with Tap as room controller, but can be substituted with the Tap IP using the connection methods detailed here: Wiring configurations for Tap and Tap IP.

• USB Mode: Dedicated PC configuration

• USB Mode: BYOD configuration HDMI + USB

• USB Mode: BYOD configuration w/ DP Alt Mode

• USB Mode: with Swytch

Dedicated Computer Setup

Shown with Logitech Tap

BYOD option 1

This option uses the included USB 2.0 cable along with a user-supplied HDMI cable to connect to the laptop.

BYOD option 2

MeetUp 2 supports DisplayPort Alt Mode (DP Alt Mode) allowing for a single cable connection between MeetUp 2 and a USB C port on a laptop.  This USB cable must specifically support DP Alt Mode - not all USB C cables support this (note: the USB 2.0 cable included with MeetUp 2 does not support DP Alt Mode).  A 5m Active USB Cable that supports DP Alt Mode is available from Logitech.