My headset does not enter pairing mode

If your headset doesn’t enter pairing mode, try resetting the headset. This will cause the headset to disconnect and return to the original factory settings.

To reset your headset

1. Enter Pairing Position: Begin by sliding the power switch to the pairing position and holding it there.

2. Press and Hold Buttons: While continuing to hold the power switch in the pairing position, simultaneously press and hold the Volume Up (+) button.

3. Wait for Confirmation: Keep holding both the power switch and the Volume Up button for approximately 5 seconds. You will know the reset has been triggered when the LED indicator begins to flash red.

4. Release and Reboot: Once you see the red flashing light, you can release both buttons. The headset will automatically process the factory reset and then reboot.

You may also conduct factory reset on Logi Tune

1. Select your headset under “Devices” list.

2. Click on the (i) button on the top right.

3. Click "Factory reset" , then select “Proceed to factory reset” to restore factory settings.

After the reset, the headset will have "forgotten" its connection to your phone, computer, or other devices. To ensure a successful new connection, you must complete one final step

1. Go to the Bluetooth settings on the device you want to connect to.

2. Find your headset in the list of previously connected devices.

3. Select the option to "Forget Device" or "Remove Device".

4. After you have removed the old pairing from your device's memory, you can now pair the headset again as if it were a new device.